- Compressors
- Reciprocating compressors
- Screw Compressors
- Blowers
- Pneumatic preparatory groups
- Systems for the recovery of waste heat
- Pipe systems
- Condensation-treatment system
- Compressed Air Tanks
- Nitrogen Generators
- Vacuum machines
- Chillers - Water Coolers
- Dryers for compressed air
- Systems for blow molding of PET bottles
- Total control of compressors
- Compressor pumps
- Packaging
- Stretch wrapping machines
- Shrink wrapping machines
- Strapping machines for plastic strap
- Vertical and horizontal flow packaging machines
- Molding, dosing and sealing machines for food industry
- Machines for surface protection and filling
- Heat sealing machines for plastic bags
- Strapping tools for steel strap
- Strapping tools for plastic strap
- Carton forming and closing machines with adhesive tapes
- Dispensers and sewing machines
- Waste presses
- Consumables
- Fastening systems
- Lifting, handling and weighting equipment
CS960
• Wider cuts : 160mm (6" 1/3)
• Higher cuts : 110mm (4" 1/3)
• Available in 400V triple phase or 230V triple phase
• Horizontal cutting stroke
Improves quality of cutting even on very delicate mouldings.
• Foot-operated pneumatic clampings
2 built-in horizontal & adjustable clamps. Firmly secure difficult mouldings in order to
avoid them from moving or rocking during the cutting operation. They are foot operated
for a « hands-free » operation.
• Hand-operated cutting stroke
Very easy moving of the handles thanks to a special pneumatic device, with an automatic
return.
• 45˚ measuring scale
Allows a direct, speed and accurate measuring
• No wastage
Because the blades cut alternately, the waste is effectively nil, which will save a lot of
meters of mouldings, and hence money, over the life of the saw.
• Internal cutting support block
This supports the offcut and prevents chipping on the back edge of the chop.
• 1.5m support arms
Robust feed-in support arm, and feed-out measuring arm.
• No blocked chutes
Because offcuts fall directly into the open waste bin below the cut, there is no need for
wastage chutes, which could be easily blocked by large offcuts.
• Ducted extraction at blades ( see doc)
This dramatically reduces dust by extracting it at the source : the blades.